25
4.2.2.2 Folding the Clamp Up (inward toward the pump)
4.2.2.3 Rotating the Clamp
4.3
Attaching the pump(s)
4.3.1
Attaching to a Pole
4.3.2
Attaching to a Rail
You can fold the clamp up as follows:
1.
Push the release button.
2.
Fold the pole clamp inward toward the pump.
You can rotate the clamp as follows:
1.
Fold the clamp up (see above).
2.
Rotate the clamp to a vertical position.
3.
If necessary, fold the clamp outward (see
above).
1.
Fold the pole clamp down to the horizontal position:
2.
Unscrew the clamp, attach to the pole, and
screw the clamp until the pump is fully secured
to the pole.
3.
Make sure that the pump is securely attached.
For more information on installing the pump on a
pole, consult the pole’s Instructions for Use.
Only single pumps can be attached to a bed rail or gurney rail.
1.
Rotate the pole clamp to the vertical position: see section 4.2.2.3, page 25.
2.
Unscrew the clamp, attach to the rail, and screw
the clamp until pump is fully secured to the rail.
3.
Make sure that the pump is securely attached.