Control PCB assembly
1.
Solder the resistors
2.
Solder the BC547
–
watch the polarity.
3.
Solder the 2 x pots.
4.
Solder the 2 x switches and 3 x sockets. Use the panel to ensure these line up nicely.
You can use cut off resistor legs to make the ground connections of the sockets.
5.
Cut female headers to size and solder them into place. Make sure that they stick out
of the bottom of the PCB.
6.
Solder the LED. Use the panel to ensure that these line up nicely
Bolt the pots, switches and the sockets to the panel using their nuts and washers. Looks nice
huh?
Calibration
1.
There is nothing to calibrate on this module
–
cool!
2.
Check it out now funk soul brother.
