freightliner Run Smart ARGOSY, Driver Manual

Page: 140 / 166

Care of Fiberglass Parts
Wash unpainted fiberglass air fairings and shields
monthly with a mild detergent, such as dishwashing
liquid. Avoid strong alkaline cleansers.
Apply a wax specifically designed for fiberglass.
Care of Chrome Parts
To prevent rust, keep chrome parts clean and pro-
tected at all times. This is especially important during
winter driving and in coastal areas where there is
exposure to salt air.
When cleaning chrome parts, use clean water and a
soft cloth or sponge. A mild detergent may also be
used.
Sponge gently, then rinse. If necessary, use a non-
abrasive chrome cleaner to remove stubborn rust or
other material. Do not use steel wool.
To help protect the chrome after cleaning, apply a
coat of polishing wax to the surface. Never use wax
on parts that are exposed to high heat, such as ex-
haust pipes.
Dashboard Care
NOTICE
When cleaning the dashboard, instrument panel,
or gauge lens covers, do not use Armor-All Pro-
tectant®, STP Son-of-a-Gun®, window cleaner, or
other equivalent treatments. These cleaners con-
tain vinyl plasticizers which can cause stress
crazing in the interior plastic panels and can re-
sult in cracking of the panels. Some cleaners can
also have an adverse effect on the clear plastic
of instrument panels and gauge lens covers, re-
sulting in a foggy or cloudy appearance. This
type of damage is not covered by vehicle war-
ranty.
To clean the dashboard, instrument panel, and gauge
lens covers, use a cloth dampened with warm soapy
water. Make certain to wring the cloth out well before
cleaning, as excess water will damage the electrical
components.
Vinyl Upholstery Cleaning
To prevent soiling, frequent vacuuming or light brush-
ing to remove dust and dirt is recommended. Harsh
cleaning agents can cause permanent damage to
vinyl upholstery. To preserve the upholstery and pre-
vent damage, carefully review the following sections
for recommended cleaning procedures. Waxing or
refinishing improves soil resistance and cleanability
for all vinyls. Any hard wax, such as that used on
automobiles, may be used.
Ordinary Dirt
Wash the upholstery with warm water and mild soap,
such as saddle or oil soap. Apply soapy water to a
large area and allow to soak for a few minutes, then
rub briskly with a cloth to remove the dirt. This can
be repeated several times, as necessary.
If dirt is deeply imbedded, use a soft bristle brush
after applying the soap.
If dirt is extremely difficult to remove, wall-washing
preparations normally found around the home can be
used. Powdered cleaners, such as those used for
sinks and tiles, are abrasive and must be used with
caution as they can scratch the vinyl or give it a per-
manent dull appearance.
Chewing Gum
Harden the gum with an ice cube wrapped in a plas-
tic bag, then scrape it off with a dull knife. Any re-
maining traces of gum can be removed with an all-
purpose light oil (peanut butter will also work) and
wiped off.
Tars, Asphalts, and Creosote
Each of these items stains vinyl after prolonged con-
tact. They should be wiped off immediately and the
area carefully cleaned, using a cloth dampened with
naphtha.
Paint, Shoe Heel Marks
Paint should be removed immediately. Do not use
paint remover or liquid-type brush cleaner on vinyl.
An unprinted cloth, dampened with naphtha or tur-
pentine may be used. Use care to prevent contact
with parts of the upholstery that are not vinyl.
Cab Appearance
20.1