freightliner PX113064S T 2016, Manual

Page: 208 / 236

steps could result in serious personal injury or
death.
2.
Open the hood. Remove the tow loops, located
behind the driver’s-side bumper. See
Fig. 19.6 .
Close and latch the hood.
NOTICE
New or ungreased tow loops may be hard to
install. Tow loops that are not properly installed
may be damaged or break.
3. Install the tow loops onto the tow loop receivers
through the tow loop holes in the bumper. Pull
the tow loops to ensure they are securely
engaged in the tow loop receivers.
4. Lower the stinger assembly so that it is level and
approximately 1 inch (0.3 cm) off the ground.
Back the tow truck so that the crossbar with lift
adaptors is within 6 inches (15 cm) of the
aerodynamic bumper. See
Fig. 19.7 .
NOTICE
When using tow loops to move the vehicle, do
not pass a sling (for example, a rope or chain)
from one loop to another. Known as reeving, this
IMPORTANT: Do not reeve when towing.
1. Tow Loop 2. Chain
Fig. 19.5, Reeving
f130146a 06/02/2022
Fig. 19.6, Tow Loops
In An Emergency
19.5