freightliner NEW CASCADIA 2016 Driver Manual Download Page 7

Page: 7 / 207

Component Information Label

NOTE: Labels shown in this chapter are ex-
amples only. Actual specifications may vary from
vehicle to vehicle.

The component information label lists the vehicle
model, identification number, and major component
models and serial numbers. See

Fig. 1.1

. The com-

ponent information label is attached to the outside of
the ziplock document bag.

Component GWR Label

The component GWR label is located on the
passenger-side B-pillar. See

Fig. 1.2

. The label pro-

vides maximum GWR ratings for each component.

See

Fig. 1.3

for a typical component GWR label.

Federal Motor Vehicle Safety
Standard Labels

NOTE: Due to the variety of Federal Motor Ve-
hicle Safety Standard (FMVSS) certification re-
quirements, not all of the labels shown will apply
to your vehicle.

Tractors with or without fifth wheels purchased in the
U.S. are marked as certified by means of an FMVSS
certification label. See

Fig. 1.4

. This label is attached

to the driver-side B-pillar, as shown in

Fig. 1.2

The tire and rim portion of the FMVSS certification
label certifies suitable tire and rim combinations that
can be installed on the vehicle, for the given gross
axle weight rating. Tires and rims installed on the
vehicle at the time of manufacture may have a higher
load capacity than that certified by the tire and rim

label. If the tires and rims currently on the vehicle
have a lower load capacity than that shown on the
tire and rim label, then the tires and rims determine
the load limitations on each of the axles.

Tractors built without a fifth wheel that are intended
for service in the U.S. have an incomplete vehicle
certification label and a final certification label at-
tached by the final-stage manufacturer. The incom-
plete vehicle document included with the vehicle cer-
tifies that the vehicle conforms to all applicable
FMVSS regulations in effect on the date of comple-
tion.

Canadian Motor Vehicle Safety
Standard Labels

In Canada, tractors with fifth wheels are marked as
certified by means of the Canadian National Safety
Mark printed on the vehicle certification label, which
is attached to the driver-side door frame B-pillar. See

Fig. 1.5

Trucks built without a cargo body and tractors built
without a fifth wheel that are intended for service in
Canada have an incomplete vehicle certification label
attached to the driver-side B-pillar. After completion
of the vehicle, a complete certification label must be
attached by the final-stage manufacturer to certify
that the vehicle conforms to all applicable Canada
Motor Vehicle Safety Standard (CMVSS) regulations
in effect on the date of completion.

Emissions Labels

Aftertreatment System Indicators
Label

Engines and vehicles manufactured after December
31, 2006 and domiciled in the U.S. or Canada are
required to meet all EPA regulations effective as of
the vehicle build date, and are equipped with an
emission aftertreatment system (ATS). Vehicles do-
miciled outside of the U.S. and Canada may not
have aftertreatment equipment, depending upon local
statutory emissions guidelines. See

Table 1.1

f080196

06/21/2016

MANUFACTURED BY: DAIMLER TRUCKS NORTH AMERICA LLC

COMPONENT INFORMATION

SEE VEHICLE ID NO.

WHEN ORDERING PARTS

PX113064S T

BASE MODEL:

CA113DC

DATE OF MFR:

07/15