The LED turns on. During the wash program in progress, the cycle can be stopped by pressing the
START/PAUSE button for a couple of seconds.
At this point, the wash program stops and you can make changes to the wash options (enabled
depending on which stage of the wash cycle you are in). If the water temperature is below 50°C,
the door can be opened (about 2 minutes after enabling the pause function) to load/empty any
laundry. To re-enable the wash phase press the START/PAUSE button again.
N.B. if, during a pause, no operation is carried out, the wash phase will restart automatically after
5 minutes.
•
CONTROL LOCK (child safety lock)
To activate the control panel lock, simultaneously press the
B-E
(lock symbol)
buttons; three horizontal lines will
appear on the display.
If, during the wash cycle or at the end of the cycle, you wish to reactivate the controls, press buttons
B-E
simultaneously,
until the three horizontal lines disappear.
• DISINFECTING
THE
DRUM
90°
Frequent washes at low temperatures may encourage the formation of mildew and unpleasant odours inside the
washing machine. The
DRUM DISINFECTION
function thoroughly cleans the machine with a special cycle at 90°C.
DRUM DISINFECTION
automatically recommends, through the blinking of the abbreviation
on the display, that
you start the cleaning program after a certain number of washes, if high temperature cycles have not been selected
during the period.
Remove all laundry from the drum, put the knob
I
on the
DRUM DISINFECTION
program and press the start H button
to start the cycle. The
DRUM DISINFECTION
program can be performed at any time or when conditions require it.
Empty the washing machine drum and close the door. Put the knob I on the
DRUM DISINFECTION
program, keep the
button (
) pressed until the abbreviation
appears on the display. Press
H
to start the
DRUM DISINFECTION
cycle.
• EASY
LOGIC
The EASY LOGIC automatically adjusts washing time, water and energy consumption based on the actual amount of
laundry loaded in the machine.
The 1/2 load function is unnecessary as the EASY LOGIC system automatically sets the wash parameters.
GB
11
CONTROL PANEL
CONTROL PANEL
Summary of Contents for WIE1210
