Freewing Super Scorpion, User Manual, Page: 8 / 28

Nose Gear Door Installation
Accessories list
A- Spring
B- Nose cabin door
1.As shown in the photo to the right, snap the "Nose
gear door (B)" to the fuselage.
2.Connect the "Spring (A)".
Main Gear Installation
Accessories list
A-Electric Retract
B-Attachment pin
C-Main gear upper strut
D-Main gear slant supporting rod
E-Main gear lower strut
F-Spring
G-Wheel shaft
H-Wheel
I - Pin
J-E-clip
(01.5mm)
K- Grub screw (M3x3mm)
L- Grub screw s (M4x3mm 4pcs )
(PM3x4mm 2pcs)
(KA3x 12mm 4 pcs)
M-Screws
N-Screws
O-Screw
(PM2x4mm)
G
�--.
H
1
---------- K 3
0
\
i. ..
Super Scorpion
Item No.: FJ207
Version No.: FJ207-V01
-7-
P-Main gear door
Q-Landing gear
R-Landing gear decal
1. Insert the "Attachment pin(B)"into the Electric
retract(A)"and use 2 "Grub screws(K)" to secure it.
2. Put the "Main gear upper strut(C)"on the
"Attachment pin(B)"and use 2 "Grub screws(L) to
secure it.
3. Put the "Main gear slant supporting rod(D)"on the
end of the "Main gear upper strut(C)"and use 2
"Grub screws (L)" to secure it.
4. Use "Pin(I)" and "E-clip(J)"to connect the "Main gear
slant supporting rod(D)"to the "Main gear lower
strut(E)"
5. Use 2 "screws(M)"to attach both ends of the
"Spring(F)"to the "Main gear slant supporting
rod(D)"and the "Main gear upper strut(C)".
Insert the "Wheel shaft(G)"into the "Wheel(H)"and
then into the hole in the " Main gear lower strut(E)"then
use "grub screw(K)" to secure the "Wheel shaft(G)" to
the Main gear lower strut(E)" .
Place the assembled "Main landing gear(Q)"in to the
landing gear hard point and use 4 "Screws(N)" to
secure it to the main wing.
Feed the wires through the wire trough.
Use 1 "Screw(O)"to mount the landing gear door to the
"Main gear slant supporting rod(D)".
Use glue to attach the "Landing gear decal(R)"to the
main wing as shown.
6.
7.
8.
9.
10.