Page
7
of
12
Display Content
Flex R1 interface
2.
Precautions
Take care when using the display and do not connect/disconnect it while the power is on.
Avoid striking or knocking the display
Do not remove the waterproof film attached to the display as this may impair its waterproofing.
In the case of errors or malfunctions, email support@freeweelcom.
3.
Operation
3.1.
Power On/Off
Press and hold M for several seconds to toggle the power on or off to both the display and controller. While the
power is off, the display will no longer consume power with a leakage current is less than 1uA.
The bike will be shut down automatically if it is left idle for 10 minutes.
3.2.
Selecting Speed Mode (Speed/Trip/ODO)
On turning on the display the default mode is current speed. Pressing
M
will cycle through the other modes in the
order of: current speed→Single trip→ODO. If the current speed
i
s over 0 km/h, after 2 seconds the mode will return
to Current speed.
Speed
Single
（
TRIP
）
