995066 - Revision A
Page 17 of 41
Step 4 - Remove the cable from any clips that are routing it along the Stand Aid.
Refitting / Replacement
Step 5 - Refitting is a reversal of the removal process noting the following points:
A)
When fitting the Cable into the Actuator port, ensure the locator is facing downward
as shown in the image.
B)
9.2.3 – Cable – Leg Actuator
Removal
Step 1 – Remove the Jack End of the Cable which ports the Control Box by pulling
downward. (This is the port on the right hand side of the Control Box as shown in the image)