FreeWave Technologies
900 MHz High Throughput Installation Guide
V10a
LIG0006AA Rev A
6 of 8
Table 3 below is similar to the Table 2, but shows the information for the 6 dB Yagi antenna.
Follow the steps below to configure the Power Output Level:
9
Start HyperTerminal or equivalent emulation program on the computer connected to the
transceiver’s Diagnostic port. (Refer to the FGR User Manual for the HyperTerminal
setup instructions). EZConfig may also be used to configure the FGR-HT transceiver.
(Refer to the EZConfig user manual for further use of the software.)
9
Invoke the setup menu on the transceiver.
9
Choose option number “3” from the Main Menu which appeared on the “Hyper Terminal”
window.
9
Choose option number “5” from the “Radio Modem Parameters” menu followed by the
appropriate RFXmitPower value, as defined from the previous tables.
6.
Repeat the steps above for each transceiver in the network.
NOTE.
Please, be advised that antennas other than listed in this section can potentially be
used with the transceiver provided that:
•
these antennas are of a similar type to the listed above;
•
antenna gain does not exceed 5 dB for omni-directional and 10 dB for directional
antenna;
•
overall system EIRP does not exceed 36 dBm.
WARNING: Any antenna other than listed in this section needs to be approved by
FreeWave Technologies before its use to assure that the transceiver in
combination with the new antenna meets FCC requirements.
Table 3:
EIRP for 6dB Yagi Antenna, Cable loss vs. RF
Xmit Power Setting.
Cable Loss
1dB 2dB 3dB 4dB
RF Xmit
10
34.40 33.40 32.40 31.40
Power
9
33.40 32.40 31.40 30.40
8
32.39 31.39 30.39 29.39
7
31.24 30.24 29.24 28.24
6
29.90 28.90 27.90 26.90
