6
MARINER TIDE 600
Instruction Manual
TO SET THE TIMER
When setting the timer, the S1 TIDE button will be used to increase the digit and the S2 RESET button
will be used to decrease the digit. Holding down either button will speed up the process.
1. Press the S3 MODE button until it shows the TIMER display.
2. Press and hold the S4 SET button for approximately 4 seconds. The message “SET TIMER”
will be displayed and hours digits will blink. Use the S1 TIDE button and S2 RESET button
to increase or decrease the digit.
3. Press the S3 MODE button, the minutes will blink. Use the S1 TIDE button and S2 RESET button
to increase or decrease the digit.
4. Press the S3 MODE button, the seconds will blink. Use the S1 TIDE button and S2 RESET button
to increase or decrease the digit.
5. Press the S3 MODE button, the action-at-end setting will blink. Press the S1 TIDE button
or S2 RESET button to select one of the following three options:
STOP AT END: the timer will stop when the countdown reaches zero
REPEAT AT END: the timer will reload and repeat the countdown when the countdown reaches zero
with the repetition number updated.
UP AT END: the timer will count up to a maximum of 23 hours, 59 minutes, and 59 seconds
when the countdown reaches zero.
6. Press the S4 SET button to confirm
TO USE THE TIMER
1. Press the S3 MODE button until it shows the TIMER display.
2. Press the S1 TIDE button to start counting down.
3. To stop the countdown, press the S2 RESET button. Press the S1 TIDE button to resume.
4. To reload the timer, press the S2 RESET button to stop the counting and then press and hold
the S2 RESET button to reset.
5. When the countdown is complete, the watch will respond according to the action-at-end setting.
STOP AT END: the timer will stop when the countdown reaches zero. A timer alert tune will be emitted
and the backlight will flash.
REPEAT AT END: the timer will reload and repeat the countdown when the countdown reaches zero
with the repetition number updated. If the timer is set for less than 30 seconds, the timer will repeat
with a beep generated. If the time is set to be 30 seconds or more, the timer will repeat and a timer
alert tune will be emitted and the backlight will flash.
UP AT END: the timer will count up to a maximum of 23 hours, 59 minutes, and 59 seconds
when the countdown reaches zero. A timer alert tune will be emitted and the backlight will flash.
NOTE: You can leave the timer running while switching to other modes. Depending on which option
is chosen, one of the following timer indicators will be displayed on the NORMAL TIME
or TIME 2 screen: (graphic) STOP AT END / (graphic) REPEAT AT END / (graphic) UP AT END.
