MSC8156-EVM Hardware Getting Started, Rev. 0
10
Freescale Semiconductor
Getting Started Procedure
10 Getting Started Procedure
Use the following steps to set up and initial the EVM:
1. Review the kit contents as listed in
Section 4 Hardware Kit Contents
and make sure you have all the
components.
2. Review the default switch settings as listed in
Section 5 DIP Switch Location Default Settings
and
verify that all switches on the board are set correctly.
3. Review the jumper settings as listed in
Section 7 Jumper Default Settings
and verify that all jumpers
are set correctly for your desired configuration.
4. Assemble and connect the 12 V power supply (see
Figure 5
) using the following steps:
a) Make sure that all power is turned off.
b) Assemble the AC/DC power supply kit, as follows:
— Attach the power cable with the country-specific wall output plug for your area.
— Attach the cable with the plug for the board connection.
c) Connect the AC/DC power supply cable to the 12 V (P5) board jack.
d) Plug the power cable into the wall outlet.
5. Referring to the information listed in
Section 6 Power Switch and Push Buttons
and
Section 9 LED
Indicators
, perform the initial power up and check using the following steps:
a) Move the power switch (S1) to the ON position, and check for completion of the PRESET
sequence; LEDs 3 (12V POWER) and LED 1 (POWER GOOD) display a constant green light.
b) Power the system off by moving the power switch (S1) to the OFF position.
Figure 5. Power and Cable Connections
