Interconnect Board Description
KIT33912EVME System Basis Chip with LIN Tranceiver Setup Instructions, Rev. 2.0
28
Freescale Semiconductor
9.4
J3 External Control
The following connector, see
, is appointed as the external control of the MC33912 device. The choice between
on-board control through the MCU, or external control, is made through Jumpers JP10 - JP20.
Table 9-3. External Control Pin Description
Terminal
Terminal Name
Definition
1
LINRXD
This terminal is the receiver output of the LIN
interface which reports the state of the bus
voltage to the MCU interface.
2
LINTXD
This terminal is the transmitter input of the LIN
interface which controls the state.
3
MISO
SPI (Serial Peripheral Interface) data sent to the
controller by the MC33912.
4
MOSI
SPI (Serial Peripheral Interface) data received by
the MC33912.
5
SCLK
SPI (Serial Peripheral Interface) clock input.
6
CS
SPI (Serial Peripheral Interface) control chip
select input terminal.
7
PGND
Power ground.
8
PWMIN
High Sides and Low Sides Pulse Width
Modulation Input.
9
RST
Reset I/O terminal. This is bidirectional allowing a
reset of the entire system. It is driven low when
any internal reset source is asserted.
10
IRQ
Interrupt output terminal, indicating wake-up
events from Stop Mode or events from Normal
and Normal Request Modes.
11
AGND
Analogue ground.
12
AGND
Analogue ground.
13
ADOUT1
Current sense analogue output.
14
ADOUT0
Analogue multiplexer output.
9.5
CON1 LIN Bus Connector
The LIN bus terminal provides a physical layer for single wire communication in automotive applications. The LIN terminal is
optionally attached to the LIN physical interface device (place Jumper JP205).
shows the three pin connector standard
definition.
Table 9-4. LIN Connector Pin Out
Terminal
Terminal Name
Definition
1
LGND
LIN ground.
2
VBAT
Supply voltage
3
LIN
LIN interconnect terminal