Freescale Semiconductor KIT33912EVME, Setup Instructions

Page: 24 / 50

User Helpful Control Page
KIT33912EVME System Basis Chip with LIN Tranceiver Setup Instructions, Rev. 2.0
16 Freescale Semiconductor
Chapter 5 User Helpful Control Page
5.1 Overview
This section provides an overview on how to control the KIT33912EVME board from the User Helpful control page. The aim of
this control environment is simplify control of the evaluation module.
• 5.2, Setup Instruction
• 5.3, Description of User Helpful Page
• 5.4, SPI Status Control Registers Tab Panels
• 5.5, System Status Register and SPI Status Registers
• 5.6, Sequence Pane
5.2 Setup Instruction
Before switching the power on, place the communication jumpers JP202 (TxD), JP203 (RxD) in position 1-2, short the supply
jumpers JP7 (VDD), JP8 (VS2) and JP9 (VS1), and then place the control jumpers JP10 - JP16, JP19 and JP20 in position 1-2.
To disable the LIN physical interface MCZ33661EF device, place jumper JP204.
5.3 Description of User Helpful Page
The User Helpful control page has some of the same panels as the FreeMASTER or LIN Master control pages, such as Graph,
Pulse Width Modulation, Wake-up Sources, SPI Watchdog, Last Error Message and System Status Register. The array of SPI
Status/Control Registers is rearranged between tab panels, where each tab shows the control or presents possibilities for the
relevant register. The status registers are included in the tab panels too, but for a convenient overview of the device state, they
are presented again and together in one different block. The control panel contains one additional function, which is the ability to
create a sequence of control commands.
2
1
4
5
6
9
7
8
3
10
11
Figure 5-1. GUI for SBCLIN - User Helpful Control