KIT33903 Evaluation Boards
, Rev. 1.0
Freescale Semiconductor
15
Using the EVB
7.1.4
Sequential Mode
Options to send SPI commands
Hexadecimal value of SPI
command sent and received
Stores commands sent
in a text file
Inserts a wait time in
millisecond increments
Removes selected lines
from list of commands
Allows user to loop
between selected
command lines
Runs loop enabled
sequence or single
sweep of commands
Stores commands sent
in a text file
Clears all commands from list
Allows user to load
list of commands in
text file format
Allows user to change Hexadecimal
or delay time value
Commands sent and
received from the SBC’s
MOSI and MISO pins
Figure 8. SPIGen Graphical User Interface (Sequential Mode)
1. Click
Sequential Mode
tab. This window displays all commands in the Sequential Mode sequence as
shown in
Figure 8
.
2. In the
Insert Wait
text box, enter a wait time in millisecond increments.
3. Click
Remove Selected Line
to remove selected lines from the list of commnads.
4. Select
Loop Enable
option to allow loop between selected lines.
5. Click
Run
to activate the loop enabled sequence or single sweep of commands.
6. Click
Save
to store commands sent in a text file.
7. Click
Load
to load list of commands in text file format.
8. Click
Clear
lists
to clear all commands from the list.
9. Enter a value in the text box and click
Change Value
to change the hexadecimal or the delay time
value.
