Freescale Semiconductor
4
4.1 Configuring the Application Module for independent operation
1)
By default, the application module is configured to run independently out of the box. Verify that
all the jumper settings are configured properly on the application module as shown by Figure 1.
2)
Plug in the USB cable from the host PC (running CodeWarrior) to the Application Module.
3)
Your Done! Proceed to Running your Demonstration application.
Figure 1. Application Module: Independent Operation Jumper Settings
Jumper Position
Jumper ID
Description
VR1
VB
VX_EN
PWR_SEL
Source power input from connector on-board USB.
SW1
SW2
SW3_1
SW3_2
SW3_3
SW3_4
USER
Jumpers enable access to application modules features. For
push button switch (SW1:2), 4-position DIP switch 3
(SW3_1:4), LED[1:4], and to simplify circuit connections and
emphasize software development.
