Freescale Semiconductor
20
1)
Make sure power is applied to the project board. If not, go back and complete hardware setup section
instructions.
2)
Start debugger.
a)
From the main menu bar in CodeWarrior IDE, select Project.
b)
Select Debug — the Debugger window will open in MultilinkCyclonePro target.
c)
You will be prompted by a Loader Warning window that the debugger will mass-erase and
program the microcontroller with your application. Click OK to continue.
NOTE
If prompted by debugger with a communication setup window, select the appropriate host PC USB port
being used by the BDM pod and click OK.
d)
Once the debugger is launched a window similar to Figure 16 will appear. The operation of the
various sub windows is listed in Table 1 on the subsequent page. The configuration of sub-
windows can be user configured and saved using File->Save Workspace
Figure 16. CodeWarrior Debugger Window
Table 1. Debugger Window Descriptions
Window Name
Description
Source and Assembly
Display programmed application software in C and
assembly programming languages, respectively
Register
Displays the MCU internal registers
Memory
Displays the active value at each memory address
in the MCU internal memory map
