7
4.
6.
Backrest Angle Adjustment :
Seat Slide Adjustment:
Freerider
5.
Seat Height Adjustment:
(Fig 4).Located on the right front
side of the seat. This lever allows you to adjust your seat
forwards and backwards when sitting on the seat. Simply
pull up the lever and move in the desired position
backwards by pushing or forward by hitching. As soon as
the lever is released, the seat will lock into the new
position.
Test that the seat has fully locked by hitching
backwards and forwards.
Do not carry out this operation when your
Scooter is moving ,first stop apply the brakes and then
carry out the seat positioning.
The seat as fitted to your
Scooter, has a fold
down backrest(see Fig 5).The seat has two height positions.
Your
distributor will position the seat to allow you
the most comfortable driving position.
You may need to alter the seat
height setting at a later date, please follow these
instructions.
Westminster
1. Remove your seat from the Scooter by lifting the seat
locking lever and lifting the seat clear of the vehicle (see
Fig 1). Note :your seat can only for safety reasons be
removed when it is Turned 90 to the right from the
straight ahead driving position. Please take care when
lifting heavy weights. Place your seat on a soft clean
work area.
2. With the aid of a 17mm spanner (not supplied) loosen
the 10mm seat clamp fixing bolt (see Fig 6).
3. Remove the 10mm fixing bolt and reposition the bolt
into one of the four preferred location holes of the seat
mounting tube (see Fig 6).
4. Re-tighten the 10mm fixing bolt. Refit the seat onto
your
Scooter.
Do not have the
seat set too high, you must be able to place both feet
firmly on the Scooter's floor area.
Westminster
Stability will be
reduced the higher your seat is set on the mounting
tube. Always take great care when cornering, lean
into the corner to achieve the best stability from your
Scooter.
The angle of your backrest
can be adjusted to a comfortable driving position by
adjusting two stop bolts. To make the adjustment you will
require two 13mm spanners (not provided). Push the
backrest forwards, you will note the adjustment bolts
situated one either side of the rear of the seat (see fig 7).
First loosen the upper locking nut, rotate the bolt in or out
until the required angle is found, push the backrest fully
backwards and check the angle for comfort, re-adjust as
necessary. Adjust the opposite stop bolt until it makes
contact with the backrest. Finally tighten the two locknuts.
Both stop bolts must make contact with the two
Caution:
Warning:
FR510GDX SEAT:
Warning:
:The seat post fitted
to your Scooter is universal for a number of Freerider
model Scooters, DO not use the top hole in the
seatpost, this will allow the seat to mount too close to
the plastic bodywork and may damage it.
Warning
Warning:
4.
6.
Backrest Angle Adjustment :
Seat Slide Adjustment:
Freerider
5.
Seat Height Adjustment:
Caution:
Warning:
FR510GDX SEAT:
Warning:
Westminster
Warning:
Warning:
Stability will be
reduced the higher your seat is set on the mounting
tube. Always take great care when cornering, lean
into the corner to achieve the best stability from your
Scooter.
FIG 3
FIG 4
FIG 5
FIG 6
FIG 7
