Freemotion i Tonic, User Manual

Page: 11 / 32

9
If you have questions about maintenance or trou-
bleshooting, see HOW TO CONTACT CUSTOMER
CARE on page 2.
Regularly inspect and properly tighten all external parts
of the vibration platform. To clean the vibration plat-
form, apply a small amount of mild multi-purpose
cleaner to a 100 percent cotton cloth and wipe the con-
sole and external surfaces.
Do not spray cleaner di-
rectly onto the vibration platform or use ammonia
or acid-based cleaners to clean the vibration plat-
form.
LEVELING THE VIBRATION PLATFORM
If the vibration platform rocks slightly during use, turn
the leveling feet under the front and rear of the frame
until the rocking motion is eliminated.
HOW TO MOVE THE VIBRATION PLATFORM
Before moving the vibration platform, make sure
that the power cord is unplugged.
Due to the size and weight of the vibration plat-
form, moving it requires two persons.
While one
person lifts the upper part of the frame, lift the rear of
the frame and carefully move the vibration platform to
the desired location. Then, lower the vibration platform
to the floor.
CAUTION: To reduce the risk of injury,
bend your knees and keep your back straight.
Make sure to use your legs rather than your back
to lift the vibration platform.
HOW TO REPLACE THE FUSE
If the vibration platform does not function and the con-
sole does not light, even when the power cord is
plugged in and the on/off switch is in the on position,
the fuse may need to be replaced.
To replace the fuse, first switch the on/off switch to the
off position and unplug the power cord.
Remove the power
cord from the jack
on the right side of
the vibration plat-
form. Then, using a
flat-head screw-
driver, remove the
fuse holder located
next to the plug
jack. Remove the
fuse from the fuse
holder.
Check to see if the wire inside the fuse is intact. If the
wire is broken or faulty, discard the fuse and insert a
new fuse into the fuse holder. Note: The correct type of
fuse to use is listed on the fuse holder. Then, replace
the fuse holder and plug the power cord into the jack.
Plug in the power cord, switch the on/off switch to the
on position, and run the vibration platform to check for
correct operation.
If further assistance is needed,
see HOW TO CONTACT CUSTOMER CARE on page
2 of this manual.
M
AINTENANCE
Fuse
Cover
Plug
Jack