PROBLEM
POSSIBLE CAUSE(S)
CORRECTIVE ACTIONS
T
ool doesn’t turn on
(LED lights do not
turn on).
The internal electronics of the tool
have not reset.
The battery is low or not charged.
The battery is damaged.
The work contact element is locked
into position.
The battery terminals are dirty.
Damaged internal electronics.
T
ool doesn’t actuate
(LED lights do turn
on).
W
ork contact element is not
depressed.
W
ork contact element is jammed.
Damaged electronics.
T
ool does not
actuate (LED light
is red).
The battery charge is low.
The battery is to hot.
T
ool operates, but
no fastener is
driven.
A
fastener is jammed in the tool.
No nails in the magazine.
Incorrect fastener has been loaded.
Debris in nose piece.
Debris in magazine.
W
orn magazine or drive blade.
T
ool operates, but
does not drive the
fastener fully.
The battery has a low charge or is
damaged.
The depth adjust is set too shallow.
T
ool is not press firmly against the
workpiece.
Material and fastener length is too
rigorous on the tool.
Remove the battery from the tool, wait 3
seconds and reinsert.
Charge the battery.
Replace the battery.
Unlock the work contact element.
Clean the battery terminals.
See authorized service center.
If the tool is set in the single fire setting,
release the trigger or work contact element
Then try refiring the tool.
Unlock the work contact element.
See authorized service center.
Charge or replace battery.
Let the tool cool down.
Remove the battery from the tool and clear
the jam from the gun.
Then push the drive
blade back and reinsert the battery.
Load more fasteners in the magazine.
Insert the fasteners recommended by the
manufacturer.
Clean the nose piece with pneumatic air
tool oil and a clean cloth.
Clean the magazine with pneumatic air tool
oil and a clean cloth.
See authorized service center.
Charge or replace the battery.
Rotate the depth adjust towards the deeper
setting.
Press down more firmly on the workpiece.
Choose a more appropriate material and
fastener for your application.
TROUBLESHOOTING
WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal
injury could result. Any repairs or replacements must be done by a qualified service
person or an authorized service center.
Jammed fastener
The incorrect fastener is loaded in
the tool
Low battery charge or damaged
battery
Debris is in nose piece
Debris is in magazine
W
orn magazine
W
orn or damaged pusher spring
Load fasteners recommended by the
manufacturer
Charge or replace battery
Clean the nose piece with pneumatic air
tool oil and a clean cloth
Clean the magazine with pneumatic air tool
oil and a clean cloth
See authorized service center
See authorized service center
PROBLEM
POSSIBLE CAUSE(S)
CORRECTIVE ACTIONS
WARNING:
Only use Freeman Authorized Repair Parts. For questions please call 1-888-669-5672 or
visit our website at http://www.freemantools.com
HTTP://WWW.FREEMANTOOLS.COM
1-888-669-5672
13
HTTP://WWW.FREEMANTOOLS.COM
1-888-669-5672
12
WEARABLE PARTS
Repair parts can be ordered from our website: http://www.freemantools.com
MODEL: PE20V2118G
MODEL: PE20V2118G
