GB
GB
4.
FIRST START-UP AND CONFIGURATION
All customers are required to provide information relating to the desired
configuration and the electrical characteristics of the network to which
the station will be connected.
The Manufacturer considers the information provided during the contracting
phase to be definitive and, consequently, any configuration changes or any other
necessary activity that has not been agreed or defined during the contracting
phase will not be included in the warranty. For all these reasons, once the above
procedure has been scrupulously completed by qualified technical personnel, the
device can be considered ready for first use.
5.
INSTRUCTIONS FOR USE
The images below are for illustrative purposes and may not show all internal
components installed in the product.
5.1.
Preliminary charging operations
During the entire charging process, DO NOT remove the charging
connector from the electric vehicle. Only remove the charging connector
from the vehicle when charging operations have ended or have been
interrupted following the appropriate procedure. Removing the charging
connector from the vehicle during the charging process can cause serious
damage to property or persons.
Before starting a new charging session:
Ensure that the product and its connectors are perfectly intact, dry and free of
any impurities
Do not insert fingers or objects into the socket
Make sure that the product is not and has not been exposed to heat sources
or explosive or flammable substances
Ensure that the electric vehicle is compatible with the product’s technical
characteristics
Do not use adapters or extensions not specified by Free2Move eSolutions
S.p.A. as they may damage the product and create safety hazards for the user.
Vehicle adapters must not be used to attach a connector to a vehicle socket
Adapters between vehicle socket and plug should only be used if specifically
designated and approved by the vehicle manufacturer or the manufacturer
of the electric vehicle’s power supply equipment, in accordance with national
requirements. Such adapters must, however, comply with the requirements
of the IEC 61851-1 standard and other relevant standards governing both
the plug and socket of the adapter. The adapters must in any case be marked
with specific indications for use permitted by the manufacturer (e.g. IEC
62196). Such adapters must not allow switching between modes of operation.
29
30
