4
5
Rear Panel
Controls and Indicators
MIDI IN & OUT/THRU terminals
Used to send/receive MIDI signals
to/from a connected external MIDI
device. The external MIDI controller
can switch PA-1QG/PA-1QB’s
presets and receive/send preset
data from/to the PA-1QG/PA-1QB.
Recalling a Preset
p.6
Transmitting Data to/from an
External Device
p.7
OUTPUT terminal
Use this terminal to connect
to your amplifier/mixer , etc.
INPUT terminal
Used to connect
a guitar/
bass, another
instrument, effects
unit, etc. This
terminal has the
HTS circuit that
keeps sound
texture the same
when the effect is
turned on and off.
INPUT LEVEL select switch
This switch is used to select PA-1QG/PA-1QB’s
input level according to the output level of the
device connected to the INPUT terminal. If you
are connecting an instrument level device, set the
switch to the INPUT terminal side. Or to connect a
line level device, set it to the OUTPUT terminal side.
POWER DC9V IN terminal
Connect the dedicated AC adapter
supplied with your PA-1QG/PA-1QB
to this terminal. Use the supplied AC
adapter.
Alternatively, a power supply with a
regulated 9 VDC output and current
capacity higher than 200 mA can be
used.
Adjusting Equalizer
Editing/Writing Preset Contents
You can create your favorite tone by adjusting various parameters.
To adjust the equalizer:
1.
Press the
ON/OFF
switch to turn on the LED above it.
2.
Press the
cursor key switch to select the frequency to be adjusted (blue dot) in the equalizer display.
3.
Turn the
PARAMETER
encoder to adjust the boost amount of the selected frequency.
NOTE
The boost amount of the selected frequency is adjustable in the range of ±12 dB. The selected frequency is shown in the equalizer
display. The boost amount for the selected frequency is shown in the
LEVEL
display.
Double-clicking the
PARAMETER
encoder resets the boost amount of the selected frequency to zero. The previous value returns by
double-clicking the encoder again.
To adjust preset’s volume:
1.
Press the
ON/OFF
switch to turn on the LED above it.
2.
Press the
cursor key switch to select the
OUTPUT
(green dot) in the equalizer display.
3.
Turn the
PARAMETER
encoder to adjust the volume for the preset.
NOTE
The preset’s volume is adjustable from 0 to 127. The preset’s volume is shown in the
LEVEL
display. When all of the frequencies of the
equalizer are set to boost amount 0, unity level is obtained with the
LEVEL
value 100, and when the value is 127, the volume can be
increased up to +12 dB.
Double-clicking the
PARAMETER
encoder resets the volume back to 100. The previous value returns by double-clicking the encoder
again.
1.
Press the
ON/OFF
switch to turn on the LED above it.
2.
Press the
cursor key switch to select the parameter to be adjusted.
3.
Turn the
PARAMETER
encoder to adjust the selected parameter.
4.
Press the
SAVE
switch.
5.
The
LEVEL
display shows the destination preset number.
6.
Turn the
PARAMETER
encoder to select the desired preset number.
7.
Press the
PARAMETER
encoder to store the preset to the selected numbered location.
NOTE
When a preset’s parameter is changed, the dot at the
PRESET
display’s lower right corner illuminates. This dot turns off when the
save operation is confirmed by pressing the
PARAMETER
encoder and the parameters are written to the preset.
If the
SAVE
switch is pressed again after pressing it, then the write operation is canceled.
