Fred’s Lab TOORO, User And Service Manual

Page: 37 / 66

6.11 Modulation Matrix 6 PRESET PARAMETERS
Furthermore, there is a default assignment for vibrato via mod wheel. Whenever the
modulation amount of the mod wheel is set to 0 or modulation is disabled, a default
modulation of LFO 2 to master pitch is applied and its intensity is controlled by the mod
wheel.
6.11.9 Example 1: Applying LFO 1 Modulation on Osc 1 Pitch
ˆ
Make sure that the ALT LED is off. If not, press the ALT button to disable the
alternate mode.
ˆ
Press the L1/VL button in the sources section.
ˆ
The display will now show L1 to indicate LFO 1 as modulation source.
ˆ
Press the OSC module button once or twice until the corresponding LED is lit in
red and the display shows O1 briefly.
ˆ
Turn the second encoder to set the modulation amount for the Coarse parameter.
ˆ
Press the EXIT button in the sources section or wait a few seconds to exit the
programming mode automatically.
6.11.10 Example 2: Applying Pitch Modulation on Amplifier Pan
ˆ
Make sure that the ALT LED is on. If not, press the ALT button to enable the
alternate mode.
ˆ
Press the EA/PI button in the sources section.
ˆ
The display will now show PI to indicate pitch as modulation source.
ˆ
Press the AMP module button. The display will show AM briefly.
ˆ
Press the ALT button again to select the alternate parameters for modulation. The
ALT LED will be lit now.
ˆ
Turn the first encoder to set the modulation amount for the Pan parameter.
ˆ
Press the EXIT button in the sources section or wait a few seconds to exit the
programming mode automatically.
37