6
7
If the banknote is a suspicious one, it will be rejected and exit from the feed port
with 3 beeps. At the same time, the “ON/OFF” key will flash, and an error code will
be displayed on “Quantity Display Window” (See Figure 4). The error codes are listed
in the Troubleshooting section on pages 7 and 8.
Detecting Report and Clearing
After finishing detection, press “REP/DIR” key to enter report mode. When
checking the detection record, it is possible for you to press “REP/DIR” key repeat-
edly to display records for different denomination and its pieces by turns (See Figure
5). Press “CLR” key and hold it for 2 seconds to clear records.
Download Software
1. Turn off the banknote detector first, and then use the provided download cable
to connect the USB port on your PC to the USB port of the detector.
2. First plug-in the power adaptor. Next press and hold “CLR” key and ON/OFF key
together, then turn on the banknote detector. If twelve “dashes” (“-”) are displayed
on the display window, this means the machine has entered download mode (See
Figure 6). If the display window doesn’t display twelve pieces of “-”, please retry
steps 1 and 2 again.
3. Run the “AS410.exe” program provided to you on your PC and click the “Load
File” button to select the updated currency software (***.UPL) (See Figure 7), then
click “Upload Unit” button to download the software (See Figure 8).
4. If the download is successful, (see Figure 9) please restart the machine.
Troubleshooting
Self test error code display
The detector automatically performs a self test when powered on. If one of the
following error messages is displayed on the display window, usually it is because
the sensor is blocked by banknotes or dust. Please use a brush or a piece of soft
cloth to clean the dust on the sensor or remove the banknotes, and then restart the
machine.
Power Saving Mode
When operating on battery power, the CT-550 will power off automatically when
the detector is idle for more than 15 minutes.
Battery Status Message
When the machine is charging the battery, the Currency Type Display Window
will display “–Ch” every 5 seconds to indicate the charging status. Usually, the bat-
tery needs about 15 hours to achieve a full charge.
If the voltage is low, the Currency type Display Window will display “-Lo” at an
interval to remind the user of that the battery needs to be charged or the user should
turn off the banknote detector.
Error Code
Figure 6
Figure 7
Figure 8
Figure 9
Currency Type
Exit Direction
Total Number
Total Value
Number Of Sheets
Denomination
Figure 5
Figure 3
Figure 4
