ILLUSTRATION OF HOW TO CONNECT EACH
TREE SECTION TO THE 3-WAY PLUG (MATCH UP 1-1, 2-2, 3-3)
To Activate Lights
: There are 8 function operations to CONTROLLER BOX
1
-STEADY
2
-COMBINATION
3
-IN WAVES
4
-SEQUENTIAL
5
-SLOW GLOW
6
-SOFT EFFECT
7
-SLOW FADE
8
-SOFT EFFECT
Pressing the button once will start the lights in STEADY mode.
Pressing the button again will start the lights in COMBO.
Pressing the button a third time will start the lights in IN
WAVES mode. Keep pressing the button until you get to your
desired setting. There is a MEMORY function to the controller
box. Every time the power
Is turned on and off, the light sets will be in the same light
setting as the one it was previously set it.
PUSH BUTTON TO ACTIVATE LIGHT SETTINGS
4. Basic Disassembly Steps:
Unplug the extension cord that plugs into the wall and disconnect all power cords from
EACH tree section from the coaxial connections labeled #1, #2, #3. Take off all of your
ornaments and tree decorations before packing your tree back into its storage boxes.
Starting from the top, gently lift off each section. Each section should be packed away in the
carton that it came in. Each tree section should be turned upside down and then carefully
press branches toward center pole for easier placement into the storage box. Carefully place
the tree in its box and tape it shut.
DO NOT STORE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE
EXCEEDS 100ºF.
1 This is for decorative use only - do not immerse in water or expose to heat. Keep away from
fire.
2 When not in use, store neatly in a cool, dry location protected from sun light.
