EasyPROP Hardware Manual
Franz Achatz The Netherlands 7
Useful Hints
EasyPROP is shipped with a loaded NTSC Video Demo and the Powerselector JP4
is jumpered to USB. If you like to power the easyPROP board by your own external
Powersupply please rejumper JP4. Take care that your Powersupply matches the
required voltage and currentsettings. Do not apply more than 9 VDC to the Propeller
Board’s DC Input connector.
The Ethernet Controller Signals (CS, SCK, SI, SO, INT) are not wired to any Portpin.
Please locate your required Portpins and connect this signal by using jump-wires.
The “driver_enc28j60.spin” object uses as default the following wire setup:
ENC28J60 Signals
Propeller Port Pins
CS
P11
SCK
P12
SI
P13
SO
P14
WOL
N.C.
INT
P15
The SD Memory connector is hardwired to P0, P1, P2 and P3 because the standard
SD Memory Objects are already configured to this pins by default.
SD Memory Slot
Propeller Port Pins
DO
P0
CLK
P1
DI
P2
CS
P3
The Xbee connector is hardwired:
Xbee connector
Propeller Port Pins
CTS
P4
RTS
P5
DOUT
P6
DIN
P7
Consult the schematic diagram for detailed information.
