Page 8
For technical questions, please call 1-888-866-5797.
Item 58307
SAF
ET
Y
OP
ERA
TIO
N
M
AI
NT
ENAN
C
E
A
SSEM
B
LY
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Tool Set Up
Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent injury and distraction.
Extending the Cradle
The Cradle can be extended to support
the ends of long panels. For safe use, both
Extensions should be pulled out the same
amount to support the panel equally.
WARNING!
Failure to properly adjust the Extensions
could cause the Hoist to tip over, resulting in
serious injury and/or property damage.
1. To adjust the Extension, pull out the Lock Pin and
pull the Extension out from the end of the Cradle
Beam until it lines up with one of the three holes.
Cradle Beam
End of Extension
Lock Pin
Crossarm
Figure J:
2. Re-insert the Lock Pin to hold the Extension in place.
3. Repeat with the other Extension.
Note:
The Lock Pin will lock the Extension in three
positions. Be sure the Lock Pin is engaged in one
of these positions whenever using the Hoist.
4. Adjust both Extensions equally, and ensure that
both are locked in place using the Lock Pins.
5. To avoid damage, always retract and secure the
Extensions before transporting or storing the Hoist.
Open the Panel Support Hooks
The Panel Support Hooks, located on one
end of the each of the Crossarms, are
used to support the drywall panel.
1. Loosen the Hook Bolts of the Panel Support Hooks,
and rotate them outward to their open position.
Crossarm
Support Hook
Hook Bolt
Figure K:
2. Secure in place by tightening the Hook
Bolts. These must be in place during
use to safely support the panel.
Note:
Rotate and secure the Support Hooks into
their closed position when transporting or storing
the Hoist, to avoid damaging the Hooks.
Figure L: