800.348.2420
|
franklinwater.com
For technical assistance, parts, or repair, please contact:
Form 226203202 Rev. 000 10/19
Copyright © 2019, Franklin Electric, Co., Inc. All rights reserved.
Safety Information
This equipment should be installed and serviced by technically
qualified personnel who are familiar with the correct selection
and use of appropriate tools, equipment, and procedures. Failure
to comply with national and local electrical and plumbing codes
and within Franklin Electric recommendations may result in elec
-
trical shock or fire hazard, unsatisfactory performance, or equip
-
ment failure.
Read and follow instructions carefully to avoid injury and prop
-
erty damage. Do not disassemble or repair unit unless described
in this manual.
Failure to follow installation or operation procedures and all
applicable codes may result in the following hazards:
Product Specific Precautions
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
•
To reduce risk of electrical shock, disconnect power before
working on or around the system. More than one discon
-
nect switch may be required to de-energize the equipment
before servicing.
•
Make sure the ground terminal is connected to the motor,
control enclosures, metal plumbing, and other metal near
the motor or cable using wire no smaller than motor cable
wires.
Risk of bodily injury, electric shock,
or property damage.
•
This equipment must not be used by children or persons
with reduced physical, sensory or mental abilities, or lack
-
ing in experience and expertise, unless supervised or
instructed. Children may not use the equipment, nor may
they play with the unit or in the immediate vicinity.
•
Equipment can start automatically. Lockout-Tagout before
servicing equipment.
•
This equipment produces high temperatures during nor
-
mal operation. Use caution when contacting surfaces.
•
Operation of this equipment requires detailed installation
and operation instructions provided in this manual for use
with this product. Read entire manual before starting
installation and operation. End User should receive and
retain manual for future use.
•
Keep safety labels clean and in good condition.
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
•
To minimize risk of electrical shock, disconnect power
before working on or around the system.
•
Serious or fatal electrical shock may result from failure to
connect the ground terminal to the motor, drive, metal
plumbing, or other metal near the motor or cable, using
wire no smaller than motor cable wires.
•
Do not remove or install VFD cover for wiring, periodic
inspections, or adjustments while power is applied, or the
unit is in operation.
•
Capacitors inside the drive can still hold lethal voltage
even after power has been disconnected—ALLOW 5 MIN
-
UTES FOR DANGEROUS INTERNAL VOLTAGE TO DIS
-
CHARGE BEFORE REMOVING COVER.
•
Operate VFD and control devices with dry hands.
•
Do not use VFD if power or motor cable is damaged.
•
Do not apply power to a damaged VFD or to VFD with
missing parts.
•
Perform wiring after VFD has been mounted. Otherwise,
electric shock or bodily injury can occur.
Risk of damage to drive or other equipment.
•
Install and wire VFD according to the instructions in this
manual.
•
Take protective measures against ESD (Electrostatic Dis
-
charge) before touching control boards during inspection,
installation or repair.
•
This product is recommended for use with Franklin Electric
4-inch and 6-inch submersible motors or above-ground
centrifugal motors. Use of this unit with any other Franklin
Electric motor or with motors from other manufacturers
may result in damage to both motor and electronics.
•
In applications where water delivery is critical, a replace
-
ment pressure sensor and/or back-up system should be
readily available if the drive fails to operate as intended.
