FRÄNKISCHE ROHRWERKE Gebr. Kirchner GmbH & Co. KG
97486 Königsberg/Germany | Tel. +49 9525 88-8123 | Fax +49 9525 88-2151
[email protected] | www.fraenkische.com
status: april 2014
DRAINAGE SYSTEMS
ELECTRICAL SYSTEMS
BUILDING TECHNOLOGY
INDUSTRIAL PRODUCTS
29
374
7
Installation
WLAN Access Point 100 DATALIGHT
Attention!
If the POF-line is supposed to be put in
empty cable ducts together with the elec-
trical installation or any other operations on
the electrical installation will be necessary,
note that this work must be performed
exclusively by authorized and experienced
professionals.
Installation
Intended Use
General
Technical Data
Protection Class:
IP20 according to DIN EN 60529
Power supply:
100 – 240 V~/50-60 Hz
Operation temperature:
-5 to +45 °C
Connections:
RJ 45 (10/100 Mbit/s)
2.2 mm Duplex POF
Transmission rate:
100 Mbit/s
Transmission length:
70 m with POF 2.2 mm
Power consumption type:
≤
2.5 W
Radio range:
2.4 GHz
Radio data rates:
150 Mbit/s
Radio standard:
IEEE 802.11 b/g/n
Security/ciphering:
WEP, WPA, WPA2
The WLAN Access Point is now ready for ope-
ration with default settings. For individual set-
tings connect the WLAN Access Point via
patch cable with the LAN interface of your PC
and set up according to your wishes.
By entering the IP address http://192.168.0.5
in the browser the WLAN Access Point can be
reached.
Password: admin
WLAN SSID: DATALIGHT
Key: wireless123
This device has three operating modes. It can
be used as an Access Point for wireless com-
municating devices or as a repeater which
increases the distance of the WLAN network.
Furthermore, it can be connected to devices,
which do not have an own WLAN adapter.
Only use this device for these purposes and
operate indoors.
The WLAN Access Point extends the use of
modern mobile network technologies with
low power consumption and low-radiation
emission. With the function settings you opti-
mize the demarcation among individual
Access Points and avoid overcouplings of the
wireless areas and losses of data rates.
4
insert POF completely and fasten the terminal
2
shorten the fibre a few mm
5
attach access point into a deep installation
box
3
remove protection cap from opened terminal
connect power supply
ground wire is not necessary
1
Guideline 2002/96/CE concerning
the handling, collection, recycling
and disposal for electrical and
electronic equipment and their
components („waste electrical and
electronic equipment“, known as
WEEE). The crossed symbol on a rubbish container
indicates that the machine or device is not allowed
to be disposed of but it must be handed over to a
suitably equipped collection centre for proper recy-
cling or disposal.
