4. OPERATION INSTRUCTIONS
:
a) Open cover on battery compartment, remove battery box and unplug cable;
install four (4) new Alkaline Type AA 1.5V batteries with correct polarity
(note the +/- indication) to obtain 6V DC ± 10% at the plug.
b) Trigger the sensor with hands or a towel to check proper soap dispensing cycle.
a) Use fresh new foam soap only and clean the soap
container properly before each refill. Deposits of old
soap will lead to malfunction and jamming.
b) Do not dilute liquid soap to use in place of foam soap.
Do not use soap containing abrasives as it can clog the outlet.
c) Do not immerse the soap dispenser in water or clean it under
running water. This will lead to a short circuit.
d) Should the dispenser be out of order and batteries have
been replaced, do not attempt any repair work. Call your
dealer for professional assistance.
5. IMPORTANT NOTICE
:
AA (1.5V)
Caution : Batteries installed with incorrect polarity may cause malfunction.
TAB
Type AA 1.5V x 4
a) Remove the power supply.
b)
When the volume of foam soap is found reduced, remove the
foaming net by L key and wash it.
c) It is recommended to clean the foaming net and its outlet every
three months.
6. CLEAN THE OUTLET
:
Use the L key to remove the outlet
7. DIAGRAM AND PARTS
:
1
2
3
4
6
7
11
12
8
9
10
5
15
20
18
19
17
16
13
21
22
1. Nameplate
2. Top cover
3. Tube
4. Elbow connector
5. O ring
6. N
et outlet
7. 2M Sensor
8. Screw
9. Screw nut
10. L key
11. Mounting shaft
12. Rubber washer (top)
13. Foam pump
14. Tube spring
15. 2M Soap rubber tube
16. Control box assembly
17. Soap tank
18. Rubber washer (bottom)
19. Nylon washer
20. Screw nut
21. Base plate
22. Adapter
14
8. Connect the wires of the soap dispenser to the wire of the control box assembly (drawing 7).
9. Push the soap tank into the track. Make sure the soap pump plate is under the pump actuator before you put back the soap tank,
so the soap dispenser can work properly (drawing 8).
10. Plug-in an AC adapter or battery box to supply power (drawing 8). Installation finished.
Connect the tube of the soap dispenser to the connector on the soap pump, and push the spring to the bottom as shown
on the image (drawing 7).
2
