TECHNICAL DATA
NOTE:
CONTENTS IN BOX
INSTALLATION INSTRUCTIONS
1. Remove all contents from the package and check for completeness.
2
. Turn off water supply.
Recommended Water Pressure
Max. Water Pressure
Recommended Hot Water Temp.
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1
& NSF 61, NSF 372 and AB1953
Flow Rate
1.
6
GPM at 45 PSI
30-75 PSI
1
00
PSI
100
° F
1 3/8”
1
Faucet assembly
2
Aerator key
3
Escutcheon
4
Sealing o-ring
5
Pull out hose
6
Base p
late
7
Base plate gasket
8
Plastic flange
9
Rubber washer
10
Fixing plate
1
1
Fixing nut
1
2
Pull out supply hose
1
3
Weight
1
4
Screws
1
5
Supply hoses
3
. Cut a mounting hole 1 3/8 diameter (35mm) in the desired position in
counter top or sink (if one isn’t available).
4
.
Place the
escutcheon
(
3
)
and the
sealing o-ring
(4)
over the base of
the faucet.
If your application has 3 holes to cover, install the base plate (6) and
base plate gasket (7) over the holes and install the faucet.
If your application is a single hole, the base plate (6) and base plate
gasket (7) are optional.
ATTENTION
: The
base plate gasket
should be sitting between the
countertop and
faucet base
plate
.
DO NOT
use putty or other sealant at this location.
NOTES
:
Solid surface installation: The countertop mounting surface needs to
be flat and free of debris otherwise the faucet may not sit properly.
For tile installations, avoid installing faucet near or on top of grout lines.
This may cause a weak joint between the faucet and the counter and
could cause leaks.
5
. Install the mounting hardware to the base of faucet body in
the following order - plastic flange (
8
),
rubber washer (
9
),
fixing plate (
10
) as shown.
6
. Tighten with the fixing nut (
11
) on the base of faucet body.
9
. Connect the flexible supply hoses (1
5
) to the water supply in the
house.
1
0
. Remove the aerator using
the aerator key (2)
, turn on water,
flush the faucet for any debris and check for leaks.
Reinstall the aerator and ensure everything is functioning properly.
7
. Connect the pull out hose (
5
) to the pull out supply hose (1
2
)
.
8
. Place the weight (1
3
) on the pull out hose (
5
) with the screws (1
4
)
approximately 2” (50mm) above the bend in the bottom of the pull out
hose.
Contact us immediatly if you see inconsistencies.
Phone: (1- 800-626-5771)
website: www.frankeksd.com
email: [email protected]
ATTENTION
:
Be sure to hold pull out supply hose (12) steady
when connecting pull out hose (
5
), otherwise pull out supply hose
(12) can be loosened and possibly cause leaks.
