TECHNICAL DATA
NOTE:
CONTENTS IN BOX
Recommended Water Pressure
Max. Water Pressure
Recommended Hot Water Temp.
Hole Size For Faucet
Flow Rate
1.6 GPM at 45 PSI
30-75 PSI
100 PSI
100° F
1 3/8”
1 Pull out spray assembly
2 Rubber washer
3 Pull out hose
4 Faucet assembly
5 Rubber washer
6 Base plate
7 Base plate gasket
8 Plastic flange
9 Rubber washer
10 Fixing plate
11 Fixing nut
12 Pull out supply hose
13 Weight
14 Screws
15 Supply hoses
Contact us immediatly if you see inconsistencies.
Phone: (1- 800-626-5771)
website: www.frankeksd.com
email: [email protected]
Certi
fi
es this faucet complies with ASME A112.18.1 / CSA B125.1
& NSF 61, NSF 372 and AB1953
INSTALLATION INSTRUCTIONS
1. Remove all contents from the package and check for completeness.
3. Turn o
ff
water supply.
2. Connect the pull out spray (1) to the pull out hose assy (3) hand tight.
Ensure the rubber washer (2) is in place.
4. Cut a mounting hole 1 3/8 diameter (35mm) in the desired position in
counter top or sink (if one isn’t available).
5.
Place the rubber washer (5) over the base of the faucet.
If your application has 3 holes to cover, install the base plate (6) and
base plate gasket (7) over the holes and install the faucet.
If your application is a single hole, the base plate (6) and base plate
gasket (7) are optional.
ATTENTION
: The base plate gasket should be sitting between the
countertop and
faucet base
plate
.
DO NOT
use putty or other sealant at this location.
NOTES
:
Solid surface installation: The countertop mounting surface needs to
be
fl
at and free of debris otherwise the faucet may not sit properly.
For tile installations, avoid installing faucet near or on top of grout lines.
This may cause a weak joint between the faucet and the counter and
could cause leaks.
6. Install the mounting hardware to the base of faucet body in
the following order - plastic flange (
8
),
rubber washer (
9
),
fixing plate (
10
) as shown.
7. Tighten with the fixing nut (
11
) on the base of faucet body.
10. Connect the flexible supply hoses (1
5
) to the water supply in the
house.
11. Remove the aerator using 7/8” (22 mm) wrench, turn on water,
fl
ush the faucet for any debris and check for leaks.
Reinstall the aerator and ensure everything is functioning properly.
8.
Connect the pull out hose (3) to the pull out supply hose (1
2
)
.
9. Place the weight (1
3
) on the pull out hose (3) with the screws (1
4
)
approximately 2” (50mm) above the bend in the bottom of the pull out
hose.
ATTENTION
:
Be sure to hold pull out supply hose (12) steady
when connecting pull out hose (3), otherwise pull out supply hose
(12) can be loosened and possibly cause leaks.