EN
7
7
X
162
INSTALLATION
Drilling the Support surface and Fitting the Hood
• The Hood can be fitted directly on the lower
surface of the wall furniture units (650 mm min.
above the Cooker Top) using the snap-on Side
Supports.
• Make an opening on the lower surface inside
the furniture unit, as indicated (fig.1); the X-
measure has to be 523 mm (60 and 90 cm
hoods) and 493 mm in case of 55 cm hood
(available for the Swiss market).
• Choose the correct flange measure basing on
the air outlet diameter and insert it to the upper
air outlet opening. (fig.2)
• Screw the closing profile
20
onto the rear part
of the hood, using the screws
12f
(2.9 x 9.5)
provided. (fig.3)
• Open the sliding suction panel.
• Remove the metal grease filters one by one af-
ter having disconnected the relative fastening
elements.
• Close the sliding suction panel again.
• Insert the Hood until the snap-on side supports
click into place. (fig.4)
• Open the sliding suction panel.
• Lock in position by tightening the screws
Vf
from underneath the Hood. (fig.4)
• If necessary, adjust the whole filter holder unit
and proceed as follows:
• Loosen the four adjustment screws
Vr
and
close the sliding panel again. (fig.5)
• Move the entire filter holder unit until it is
properly aligned with the wall unit. (fig.6)
• Keeping the hood canopy still, remove the
sliding panel and lock the adjustment
screws again. (fig.5)
• The hood can now be fastened to the wall
unit using the four screws
12a
(3.5 x 16)
provided. (fig.7)
• Replace the metal grease filters.
• Close the sliding suction panel again.
1
3
4
Vr
5
6
12a
7
9
10a
10a
10b
2
