INSTALLATION INSTRUCTIONS
FRANKE
DESIGNER CERAMIC COOKTOP 60CM
page 2 of 3
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
Th
is installation has to be done carefully, in conformity of the following drawing.
• Stick the gasket (2) two millimetres from the external edge
of the glass, after removing the protection sheet (3)
Fitting - installing:
The cut out sizes are:
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The hobs are classified as “Y” class for heat protection. Ideally the hob should be installed with plenty of space on either
side. There may be a wall at the rear and tall units or a wall at one side. On the other side, however, no unit or divider
must
stand higher than the hob.
• The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture, the laminate coatings
and the glue used to fix them, must be able to resist temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
•
Do n
ot install the hob to the top of a no
n
ventilated oven or a dishwasher.
• To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good air circulation of the electronic
device.
• If a drawer is placed under the work, avoid to put into this drawer flammable objects (for example: sprays) or not heat-
resistant objects.
