Franke FMY 907 MG, User Manual, Page: 10 / 96

10
4. CONTROLS
To activate the Keyboard and its functions, press Button A . The keyboard will be displayed at half intensity. If it is not
used for 15 Seconds it will revert to its original status.
Button Function Led
A
Turns the Motor off. -
Enables / Disables Keyboard Lock mode if pressed and
held for 2 seconds.
All the Leds light up in cycle.
B Activates speed one. The Button is fully lit.
Pressing and holding the button for 2 seconds enables
the remote control.
Pressing and holding the button for 2 seconds disables
the remote control.
All Leds flash twice.
All Leds flash once.
C Activates speed two. The Button is fully lit.
D Activates speed three. The Button is fully lit.
E Activates Intensive speed. This speed is timed to run
for 6 minutes. At the end of this time the system will
automatically return to the speed set before.
It is disabled by pressing the Button or turning the
Motor off.
The button flashes once per second.
F
Activates
Delay
mode, with automatic shutdown of the
Motor, the Fans and the Lighting with a 15’ delay.
It is disabled by pressing the button or turning the
motor off.
The
Delay
Led lights up.
Press and hold the button for approximately 2 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 2
seconds.
All Leds flash twice.
All Leds flash once.
G Press briefly to turn the lighting system on and off at
maximum intensity.
-
Holding the button down for 2 seconds to switch on the
lights at a intermediate brightness.
-
H Press briefly, with all loads turned off (Motor+Lights),
when the filter alarm is active to reset the alarm. All the
Leds flash 3 times.
When the procedure terminates, the indication
shown previously turns off:
C+H Flashing
Indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
D+H Flashing
Indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 200 working hours.
5. REMOTE CONTROL
(OPTIONAL)
6. LIGHTING
• For replacement contact technical support
(“To purchase contact technical support”).