Franke FFPD100 SERIES Installation Manual Download Page 8

8

ENGLISH

Limited lifetime warranty

Franke Consumer Products, Inc., Kitchen Systems Division extends the following warranty to the origi

-

nal purchaser of its faucets effective January 1, 2003. 

All  faucets  installed  in  a  private  residence  will  carry  a 

limited  lifetime  warranty 

on  all  mechanical 

parts to be free of manufacturing defects in material and workmanship under normal usage. 

All chrome 

finishes carry a limited lifetime warranty; all other finishes are warranted for five (5) years form the 

original date of purchase.

Marine and Outdoor Installation

: Franke Consumer Products, Inc. faucets are NOT warranted for 

Marine and Outdoor installations.

This warranty applies only to the original owner, providing the product has been installed in accordance 

with our installation instructions, used as recommended and in a normal residential application. 

In the 

event of a warranty claim, the owner will be required to provide proof of purchase - save sales 

receipt

. This warranty covers all components which make the product operational. Franke, at its op

-

tion, may repair or replace the product or components necessary to restore the product to good working 

condition. Franke reserves the right to inspect the installation 

prior 

to the actual replacement of the 

product or component part.

This warranty does not cover misuse or abuse, accidental damages, scuffs or scratches, improper installa

-

tion, abnormal usage, negligence or damage caused by improper maintenance or cleaning. Normal wear 

of parts is excluded from the warranty. Damage caused by impurities or acts beyond our control are not 

covered. Any product or part which has been repaired or altered in any manner outside of Franke’s fac

-

tory, unless previously authorized in writing by Franke, will void warranty. 

Any replacement excludes 

transportation and any labor re-installation costs

. This warranty does not allow recovery of incidental 

or consequential damages such as loss of use, delay, property damage or other consequential damage, 

and Franke accepts no liability for such damages.

The Franke warranty is limited to the above conditions and to the warranty period specified herein and is 

exclusive. Franke DISCLAIMS all other warranties, expressed or implied, including IMPLIED WAR

-

RANTIES OF MERCHANTABILITY AND/OR FITNESS FOR AS PARTICULAR PURPOSE. This 

warranty gives you specific legal rights that may vary from state to state.

Further information

For any further information about our products, about the installation

of them or about the guarantee, please dial the number of the

customer service:

Phone 1-215-822-6590

Or: 1-800-626-5771

Fax 1-215-822-5873

Franke Consumer Products Inc. - Kitchen Systems Division

3050 Campus Drive, Suite 500 Hatfield, PA 19440

Summary of Contents for FFPD100 SERIES









Reviews: