5
Chapter 1
Ready, setup, go
BUTTON
LED
FUNCTION
T1
-
Turns the motor off.
All the LEDs
flash 3 times.
When the filters alarm is triggered, the alarm can be reset by
pressing and holding this button for approximately 5 seconds. These
indications are only visible when the motor is turned off. When the
procedure terminates, the indication shown previously turns off:
Led T2+Led T4 flash, indicating the need to wash the metal grease
filters. The alarm is triggered after the Hood has been in operation
for 100 working hours.
Led T2+Led T3 flash, indicating the need to change the activated
charcoal filters, and to wash the metal grease filters.
The alarm is triggered after the Hood has been in operation for
200 working hours.
T2
Fixed
Turns the motor on at speed one.
T3
Fixed
Turns the motor on at speed two.
The LED
corresponding
to the speed
that has been
set flashes once
every second
Turns the Delay Function on and off when pressed and held for 2
seconds. Activates automatic switch-off (Motor+Lights) with a 30’
delay. Suitable to complete elimination of residual odours. Can be
activated from any position when the Intensive function is disabled,
and is deactivated by pressing the button or turning the motor off.
T4
Fixed
Turns the motor on at speed two.
Flashes twice
a second.
Turns the Intensive Function on and off when pressed and held for
2 seconds. This speed is timed to run for 6 minutes. At the end of
this time, the system returns automatically to the speed that was set
before. It is disabled by pressing the button or turning the motor off.
It cannot be activated when the Delay function is active.
L
-
Turns the lighting system on and off at maximum intensity.
Press and hold the button for approximately 5 seconds, with all the
loads turned off (Motor and Lights), to turn the Activated Charcoal
Filter alarm on/off.
Led T3+Led T4 flash twice – Alarm On.
Led T3+Led T4 flash once – Alarm Off.
RANGEHOOD FUNCTIONS
T1
T2
T3
T4
L