EN
6
6
11a
1
1
11
12a
2
2
190 190
7.3
190
190
835
362
X
1÷2
7.2.1
min. 250
max. 380
INSTALLATION
Wall drilling and bracket fixing
On the wall, draw
• a Vertical line up to the ceiling or upper limit, at the centre of the area in which the Hood is
to be fitted;
• a Horizontal line at a minimum of 835 mm above the Cooker Top.
• Mark a point
(1)
on the horizontal line, 190 mm to the right of the vertical reference line.
• Repeat this operation on the other side, checking that the two marks are level.
• Mark a reference point
(2)
as indicated at 190 mm from the vertical reference line and 362
mm above the Cooker Top.
• Repeat this operation on the other side, checking that the two marks are level.
• Drill at the points
(1)
marked, using a ø 12 mm drill bit.
• Drill at the points
(2)
marked, using a ø 8 mm drill bit.
• Insert the bracket plugs
11a
into the holes
1
and screw into place.
• Insert plug
11
into hole
2
.
To install a decorative chimney ( optional )
• Place bracket
7.2.1
on the wall as shown about 1-2 mm from the ceiling or upper limit align-
ing the centre (notch) with the vertical reference line.
• Mark the wall at the centres of the holes in the bracket.
• Place bracket
7.2.1
on the wall as shown at X mm below the first bracket (X = height of the
upper chimney section supplied), aligning the centre (notch) with the vertical line.
• Mark the wall at the centres of the holes in the bracket.
• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs
11
in the holes.
• Fix the lower bracket
7.2.1
using the
12a
screws (4,2 x 44,4) supplied.
• Fix the upper bracket
7.2.1
and the air outlet connection support
7.3
together using the 2
screws
12a
(4,2 x 44,4) supplied.
Drilling measures
refer to a minimum
safety distance at
250 mm
