13
The oven is now programmed and in standby.
To check the set duration press the button
; to adjust it operate the buttons - OR + .
To check the set temperature press a button [-] or + ; to adjust it operate the knob C .
Cooking phase:
On reaching the cooking phase the oven behaves as in point B of the previous paragraph.Except that the cooking duration countdown starts immediately, and not
after the required temperature has been reached. This is because the controller assumes that the food has already been placed in the oven at the moment of
programming. The preheating time is included in the cooking time.
Failures and Error Codes ELECTRONIC PROGRAMMER ADVANCED
Whenever a failure is detected, a failure signal sounds and the display reads the belonging error code:
F3E3
Temp. sensor short circuit
F3E0
Temp. sensor open circuit
F4E0
EEPROM failure
At multiple errors, the display priority is as follows: F3E3, F3E0, F4E0.
The error message is automatically cleared when the failure is repaired. For EEPROM failure, the control has to be
reset first, for all other failures this can happen during program run.
At every failure, oven heating relay 1 is switched off.
Pos.
COOKING Mode
Display Preheat
0 Off
hh:mm No
1 Light
hh:mm No
2 Defrost
dEF
No
3 Top Heat + Grill
180°C
Yes
4 Top Heat + Grill + Fan
180°C
Yes
5 Ring E Fan
150°C
Yes
6 Ring E Top Heat + Grill + Fan
200°C
Yes
7 Ring E Bottom Heat + Grill + Fan ("Fast")
220°C Yes
8 Grill + Top Heat + Fan
160°C
No
9 Grill
220°C No
10 Grill + Fan
220°C No
