-
Using a soft bristle brush (a small clean paint brush),
carefully brush off the catalyser. Loosen any carbon
soot from the bottom of the burner with a putty knife,
and vacuum clean. Ensure that the small air holes in
burner are free of carbon.
•
At least once a year / End of heating season
:
Clean or replace all the oil filters in the oil supply line
and to change the joint of the de-scaling lever (rep. A,
fig. 18, code 142825) by a professional installer..
To clean the filter of the float regulator
:
-
set the regulation knob in closed position “0"
(# 10, fig. 16),
-
turn off the tankvalve or the valve of the oil supply
ligne,
-
raise the safety lever of the float regulator
-
place a small container (or a small rag) under the
regulator filter opening in order to collect the oil
contained in the regulator,
-
remove the filter cover plate located under the
regulator (# 3, fig. 11, p. 7) with a screwdriver,
-
remove the tubular filter from the regulator. Clean, if ne
it with oil using a soft brush, never a wire-brush,
-
replace the filter in the regulator, install the cover plate
and secure with the screw.
•
Clean all the enamelled panels of the stove with a dry
or slighly damp soft cloth.
•
Use a soft clean cloth to wipe the front glass when the
unit is running at a low burning rate. When the main
door is opened for cleaning, the flame will be disturb,
and turn to a yellow flame. Clean quickly, but gently.
Close the door, the flame will return to a normal burning
position.
N.B. : The appearance of cracks when burning the
enamelled units is quite usual and tends to disappear
when the appliance is cooling down. It should not be
considered as a defect but rather as a patina of the
enamel which does not affect its quality nor its service
ability.
3.6. Recommendation
•
The adjustment of the stove has been made at the
factory and checked by your installer. Any anomaly of
operation should be reported to him at once.
•
This room heater is a hight heat producing appliance
and may cause severe burns if touched on the glass
front door, or on top directly over the burner
KEEP CHILDREN AWAY
Do not use for drying wet clothing.
CAUTION
: Never light the burner if there is oil in the
burner pot. Clean out oil before lighting.
Racing
: An audible fluttering sound is an indication
that there is too much oil in the pot burner and/or a lack
adequate draught.
-
turn off oil supply and set the control knob in closed
position “0" (# 10, fig. 16).
-
until fire has decreased to proper burn rate.
•
Do not overfire
: If the stove or chimney connector
starts to glow, you are overfiring.
10
Technical manual “954”
“Le Beffroi” ref. 174 10 54
Operating instructions
A
Figure 18
