FrancisFrancis Y 1.1 Touch, User Manual

Page: 6 / 16

18
Insert the plug into the outlet. Consult the following chapter to
switch on the appliance.
Warning: make sure that the capsule compartment “B” is
properly closed before brewing coffee. Never open it while
coffee is being dispensed.
Note: When using the machine for the fi rst time or after
it has not been used for 7 or more days, after placing a
container of suitable capacity beneath the brew group “C”,
we suggest running at least half a tank of water through
the brew group without inserting a capsule.
TURNING ON/OFF
To turn on the machine, proceed as follows:
Check the water level in the tank “L”; if necessary add water
as previously described.
Move the main on/off switch “M” into the “I” position. The but-
tons
and will light up repeatedly from left to right.
This indicates that the machine is starting to warm up.
Place a cup beneath the brew group.
Wait until the buttons and are steadily lit and the
machine emits a beep; this indicates that the machine has
reached the correct operating temperature.
Start
Touch the button .
Wait until water fl ows out of the brew group.
The machine will automatically stop dispensing water when
the programmed quantity has been reached or you press the
buttons on the touch screen again.
Note: Only during the initial warming up phase, the machine
will not brew coffee if the buttons
and are off or fl ash-
ing.
Power Save
The machine has been programmed to protect the environment and
save energy when it is not being used.
When it has not been used for 60 minutes the machine will
switch automatically into the Power Save mode; the button
will fl ash slowly.
To switch the machine back on press one of the two buttons.
Before switching off the machine, we recommend running
about a cupful of hot water through the brew group with
the capsule compartment “B” empty.