GENERAL SAFETY RULES
WARNING
: Do not attempt to operate the machine until you have read thoroughly and understood completely all in-
structions, rules, etc. contained in this manual. Failure to comply may result in accidents involving serious personal
injury. Keep this owner's manual and review frequently for continuous safe operation.
1. Know your machine. For your own safety, read the owner's manual carefully. Learn its application and limitations,
as well as specific potential hazards pertinent to this machine.
2. Keep guards in place and in working order. If a guard must be removed for maintenance or cleaning, make sure it
is properly replaced before using the machine again.
3. Remove adjusting keys and spanners. Form a habit of checking to see that the keys and adjusting spanners are
removed from the machine before operating it.
4. Keep your work area clean. Cluttered areas and workbenches increase the chance of an accident.
5. Do not use in dangerous environments. Do not use power tools in damp or wet locations, or expose them to rain.
Keep work areas well illuminated.
6. Keep children away. All visitors should be kept a safe distance from the work area.
7. Use the right tools. Do not force the machine or attachments to do a job for which they are not designed. Contact
the manufacturer or distributor if there is any question about the machine's suitability for a particular job.
8. Wear proper apparel. Avoid loose clothing, gloves, ties, rings, bracelets, and jewellery which could get caught in
moving parts. Non-slip footwear is recommended. Wear protective hair covering to contain long hair.
9. Always use safety glasses. Normal spectacles only have impact resistant lenses. They are not
safety glasses.
10. Do not over-reach. Keep proper footing and balance at all times.
11. Maintain machine in good condition. Keep machine clean for best and safest performance. Follow instructions for
lubrication and maintenance.
12. Disconnect the machine from power or source (or air supply) before servicing.
13. Do not use any power tools while under the effects of drugs, alcohol or medication.
Page 2
M3 Technical Specification
Moulding Width (Using Rebate Clamp)
0-60mm
Moulding Width (Without Clamp)
0-100mm
Moulding Height
0-100mm
Pin Placement from Back Corner
0-110mm
Wedge Sizes
7 to 15mm
Underpinner Dimensions (WxDxH)
730mm x 800mm x 1110mm
Weight
30kg
Warranty
1 year
