Customer Service: 1800-914-9835 | [email protected]
ASSEMBLY INSTRUCTIONS
STEP 1
9
8
7
STEP 1
:
Screw the short upper tube into the middle tube and tighten.
Screw lower tube into the connected tubes and , tighten to
complete one upright pole. Repeat to build the other two upright poles.
STEP 2
:
Place T-connector into one end of each horizontal tube . To
connect the two horizontal poles, join T-connector and
L-connector to produce the corner hinge. Place the two ends of
horizontal pole without connectors into this connection hinge.
Place this assembly onto ground to attach the cross brace . Make
sure the open connector holes are facing down. Position cross brace
over the pre-drilled holes on both horizontal tubes .
Connect brace onto horizontal tube by pushing the cotter pin
through the cross brace and pre-drilled holes in the tubes, then bend
the pins to create snug fit.
Place the adapter cap on each connection point.
9
8
7
8
9
5
5
4
3
6
5
5
4
4
5
3
3
6
6
6
STEP 2
10
10
11
10
10
11
11
11
10
10
