FRAM FEK-2200BK, Manual

Page: 11 / 24

10
NOTE
：
Ensure that switch is clear of obstructions and the lid is firmly closed. The kettle will not
turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may result in
scald, besides, don’t open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before
reopening to boil water. The kettle may be stored on the power base when not in use.
NOTE
：
Ensure power supply is turned off when kettle is not in use.
BOIL-DRY PROTECT
Should you accidentally allow the kettle to operate without water, the boil-dry protection will
automatically switch it off. If this should occur, allow the kettle to cool before filling with cold water
and re-boiling.
Always disconnect the appliance from the power outlet before cleaning.
Never immerse the kettle or cord in water, or allow moisture to contact with these parts.
REMOVAL OF MINERAL DEPOSITS
Mineral deposits in tap water may cause the kettle interior to discolor .To remove this build-up, use
Liquid Descaler, a simple to use non-toxic cleaner.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder with water and be allowed to stand
overnight. Do not boil.
2. Empty the solution from the kettle. Any stains remaining inside the spout can be removed by
rubbing with a damp cloth, fill the kettle with clean water, bring to boil and then discard the water.
Repeat and the kettle will then be ready to use.
The outside of the kettle can be wiped over with a damp cloth.
Cleaning appearance of housing
Wipe the appearance of housing with a wild and damp cloth or cleaner, never use a poisonous
cleaner.
CLEANING THE FILTER
Remember to clean the filter with a wild and damp cloth at intervals. The filter can be detached for
easier cleaning simply by pulling it out.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle.
STORAGE
When not in use or storage, the power cord may be wound around the cord storage under the
bottom of kettle.
6. CLEANING AND MAINTENANCE