MIDI MENU REFERENCE
Fractal Audio Systems MFC-101 Manual
12.4.3
Axe-Fx Preset Transmit Map
EDIT : MIDI : PAGE
(3x)
The Axe-Fx Preset Transmit (“Tx”) Map is used to set up a custom map between MFC-101 presets and Axe-Fx presets. This
makes it possible for any MFC-101 preset to load any of the 384 presets from a connected Axe-Fx.
Use the
PARAMETER
footswitches to select between MFC Preset and Axe-Fx Preset.
The value “OFF” causes the current preset to send no change to the Axe-Fx, which allows you, for example, to change presets
on other components without switching the preset of a connected Axe-Fx.
12.4.4
MFC-101 MIDI Receive Channel
EDIT : MIDI : PAGE
(4x)
MFC-101 MIDI Receive (“Rx”) Channel
is used to specify the channel on which the MFC-101 will respond to MIDI program
change messages received at its MIDI IN port, if this feature is enabled (see below).
12.4.5
MFC-101 Receive Program Change
EDIT : MIDI : PAGE
(5x)
MFC-101 Receive (“Rx”) Program Change
is used to enable or disable incoming MIDI Program change response on the MFC-
101. Enabling this setting allows other devices to remote control the MFC-101 by loading its presets, which in turn send the
usual MIDI instructions to the MIDI OUT port as if they had been selected via footswitch.
12.4.6
MFC-101 Program Change Map
EDIT : MIDI : PAGE
(6x)
The
MFC-101 Program Change Map
is used to create a custom relationship between incoming MIDI program change messages
and MFC-presets. This makes it possible to recall different MFC-101 presets depending on the MIDI program change number
received.
PARAMETER
footswitches move between Incoming Program Change and MFC Preset Number parameters.
NOTE
: The range of MFC-101 Preset Numbers shown will be affected by the MFC-101 Display Offset (
).
NOTE
: Receive Program Change (
) must be enabled for the MFC-101 to respond at all to Program Changes.
Axe-Fx TxMap 000->000
MIDI Rx Channel OFF
RxProgramChange OFF
ProgChgMap 000->000
