M A N U A L O S E - C 2 3 0 0 / 2 3 0 1 V 3 . 0
Revision: 2016-07-13
Fraba GmbH
7 / 8
Zeppelinstr. 2, D - 50667 Köln
Tel.: +49 (0) 221 - 9 62 13-0, T49 (0) 221 - 9 62 13-60, www.vitector.de, [email protected]
GB
Security advice
Only instructed persons are allowed to open the housing!
High voltage inside!
Safety regulations
-
The unit should be installed and operated by persons,
who are familiar with these instructions and the current
regulations for safety at work and accident prevention.
Follow local regulations especially as regards preven-
tative measures. Safety level of machine and safety
equipment depends on reliability of the used interface.
-
Avoid mechanical vibrations greater than
5 g/33 Hz both.
-
Replacement and use of components, which are not
certified by the producer may cause safety risk. Any
guarantee is void following opening of the housing or
unauthorised modifications.
-
Adequate fuse protection must be provided on all
output contacts with capacitive and inductive loads.
-
The safety contacts are separated safely regarding to
DIN VDE 0110 part 1 up to 300 V.
Maintenance
The safety edge shall be tested yearly by optical inspec-
tion concerning defects. In case of any defect the safety
edge shall be changed because the safety function is not
guaranteed completely. The following inspections shall be
done:
-
Inspection of the rubber profile concerning defects e.g.
cracks
-
Inspection of the rubber profile concerning decreased
elasticity e.g. due to aging
-
Inspection of a close mounted seat
-
Triggering of the safety edge by hand obstructing the
rubber profile
