Copyright © 2018 FPVMODEL LIMITED
3
Your betaflight F7 has many features built into the flight controller and some of them use uart connections in a
different manner by separating and placing them in a better configuration to allow for easy connection of
some of the most commonly used features that pilots want.
ESC CONNECTION
*If using ESC telemetry Smart Audio/Tramp Telemetry signal should be connected to UART 3 TX.
Connecting ESCs to the Betaflight F7 is easier than before due to all top pad placement for ESC connection.
GND, M1-4, and BAT votage connection are easily accessed from the top side of the FC along with
Telemetry (TELE) pads for those that may be using BLHELI32 or other variants of ESCs with telemetry ability.
Looking at the flight controller this color coded chart will give you an idea of proper ESC connection with no
signal ground required.
CAMERA CONNECTION
Your FPV camera connection can easily be connected following the color coded guide below. Two things the
user will want to keep in mind. One your power supply for camera can either be 5v or battery voltage. The
power choice is up to the user and will be completed by a small solder jumper at the edge to the FC as
shown in the guide below. Two, your betaflight F7 RV1 FC comes with a soldering pad for camera control.
This gives the user the ability to control their compatibile FPV camera menu settings via osd and transmitter
sticks. This location is simply labeled CAM_C for Camera Control.
