Clear and clean the motor wires accordingly.
Step 7: Solder the camera and VTX
Use the camera cable that shows as below to solder VTX cable. Make sure the 3 soldering pads V+, CAM and
GND are soldered correctly. Or if the VTX not soldered correctly, it will not work or get burnt.
The camera power supply and VBAT cables need to be soldered onto the VBAT of flight controller. VTX red
wire soldered to BEC 5V, ground wire use GND together.
Summary of Contents for X-Racer X9
