22
Change oil filter
Only proceed with the engine stopped and at a low temperature, so
as to avoid the risk of burning.
Only use filters with a filtration level equivalent to the ones you are
replacing (see section FREQUENCY).
Place a container under the filter support, to collect the used oil.
Unscrew the filter/s (1) and remove it/them.
Carefully clean the surfaces of the support that are in contact with
the seal gasket.
Damp the new filtr/s seal with a thin layer of oil.
Hand screw the new filter into place until the seal gasket touches
the support, then lock by a further 3/4 of a turn.
Dispose of the old filter according to current requirements.
Changing the fuel filter
Only proceed with the engine stopped and at a low temperature, so
as to avoid the risk of burning.
Only use filters with a filtration level equivalent to the ones you are
replacing (see section FREQUENCY).
Remove the filter (1) by
unscrewing it.
Check that the new filter has
performance levels that
satisfy the needs of the
engine.
Damp the new filter seal
with diesel or engine oil.
Hand screw the new filter
into place until the seal
gasket touches the support,
then lock by a further 3/4 of
a turn.
Pay attention to whether or
not there is an electrical fuel
pre-heater and relevant
connector.
12_008_C
WARNING
Do not fill up the new filter before it is fitted to the support, to avoid
inserting harmful impurities into the injection system and circuit.
05_019_C
1