9650 Valve Series
Installation and Maintenance Manual
17
5)
Disconnect the stainless steel tubing to the actuator by loosening the
11
/
16
” swaged tube fittings on both ends
then remove.
6)
Unscrew the solenoid from the limit switch housing and pull out electrical leads to remove.
Assembly:
Caution: following ANY valve maintenance it is required to fully test valve operation and to complete fps valve
automated valve repair check sheet.
1)
Ensure the same model of solenoid is used in reassembly.
2)
Apply Loctite 567 Thread Sealant or similar to the solenoid threads.
3)
Follow assembly steps 2) to 6) in reverse for assembly.
4)
Following solenoid replacement, refer to section 7 for valve testing.
